How do you use the mobile beer tap?
Equipment
- Beer tap
- Keg(s)
- Keg coupler(s)
- CO₂ cylinder
- Hoses (2 or 4)
Getting started
- Plug the beer tap into a 220 V socket about twenty minutes before you need it.
- Before connecting everything, make sure the black valves on the keg couplers and on the CO₂ cylinder’s pressure regulator are closed (at right angles to the hose).
- If the hoses are not already connected, use them to connect the following parts:
- the CO₂ cylinder to the keg couplers.
- the keg couplers to the beer tap.
- Tap each keg using its coupler.
- Open the following:
- the CO₂ supply, by turning the knob in the direction indicated.
- the valves on:
- the CO₂ pressure regulator.
- the keg couplers.
- Flush the lines. When you first use the tap, it contains rinse water.
Don’t worry, there really is beer in those kegs! - Once the beer starts flowing, you’re good to go!
Final adjustments
- Adjust the beer flow using the flow control on each tap.
- Turn the temperature dial to adjust the temperature.
- The CO₂ pressure should be 2.5 bar. To adjust it, turn the centre knob on the cylinder’s pressure regulator.
A few pouring tips
For a good pour:
- Use drinking glasses. Plastic cups tend to make beer foam up.
- Rinse your glass with water before pouring. Beer flows more smoothly into a wet glass, and it’s easier to control the foam because there are fewer fine dust particles.
- Pull the tap handle and let a little foam flow out before bringing your glass up to the tap.
We’ve made a short how-to video that walks you through these steps! 👇
2023 © All Rights Reserved by CoHop – Legal notice